Australis AllShield Gloss
Guaranteed for 15 Years.
Product Code: 811-Series
Product Description
AllShield Gloss is a 100% Acrylic, designed for exterior surfaces to give long lasting protection against Australia’s severe conditions. Formulated for use direct to timber and masonry to give long lasting performance without the need for a priming coat. The product is easy to apply without messy spatter.
Areas of Use
Suitable for direct application to all types of masonry, galvanised iron, timber and suitably primed ferrous metals.
Special Features
- Water based
- Excellent weather resistance
- Needs no primer on timber
- Re-coat in 2 hours
- 100% acrylic
- Resists mould and fungal growth
Method of Application
- Brush, roller or spray
- Satisfactory with most equipment
- Observe the State Spray Painting Regulations
- Stir well before use using a broad, flat paddle in a scooping motion
- Do not apply if temperature is below 10C or likely to fall below 10C during drying
- Do not apply if rain is expected or in excessively hot, dry conditions
Coverage
Approximately 16 square metres per litre (Coverage will vary depending on the profile and porosity of the painted surface).
Thinning
Water – Use up to 100ml per litre to aid application if necessary in hot, dry conditions.
Drying(25C and 50% Relative Humidity)
- Dry to touch after 20 Minutes
- Re-coatable after 2 Hours
Clean Up
Clean all equipment with water.
Surface Preparation
Remove all soft, powdered, blistered, loose or flaking paint. Remove all traces of grease, dirt, oil or smoke using a suitable detergent. Wash with clean water and allow to dry. Repair any cracks or surface defects with a good quality filler. Sand smooth and dust off.
Previously painted surfaces must be sound and have good adhesion.This can be checked by cutting an “X” with a sharp blade, press a piece of clear tape over the “X” as firmly as possible with the ball of the thumb then as quickly as possible, tear off the tape in one movement. If the previous paint comes off it must be removed before repainting.
Note: Mould, fungal infected surfaces and efflorescence must be treated to eliminate the possibility of recurrence.
Sizes
1 Ltr, 2 Ltrs, 4 Ltrs, 10 Ltrs, 15 Ltrs.
Sample Pots also available.
Bases
White, Deep Base, Ultra Deep Base, Extra Bright Base, and a large range of colours.
View the Material Safety Data Sheet (MSDS) for information regarding Health and Safety, First Aid, and Paint Disposal Procedures.