Pristine Low Sheen

Australis Pristine Low Sheen

Guaranteed for 15 Years.

Product Code: 833-Series

Product Description

Australis Pristine Low Sheen is an Ultra Premium Interior pure acrylic formulated to allow tough everyday stains such as coffee, red wine & beetroot to be removed almost without trace. It is the best choice for walls, hallways, family rooms & ceilings. Australis Pristine is easy to apply with no messy spatter and with minimal care will give long lasting service.

Special Features

  • Water based
  • Low VOC
  • Easy to apply and clean up
  • Excellent Stain Resistance. Most stains can be removed with household cleaner such as Ajax Spray ‘n’ Wipe* within 30 minutes of contamination
  • 100% acrylic
  • Long lasting finish

Stain Removal

Pristine 833 Series has been specially developed to assist with the removal of common household stains. Stains such as coffee, red wine and beetroot may be removed almost without trace, by the use of a damp cloth and a household cleaner, such as Ajax Spray ‘n’ Wipe*. It is recommended that stains be removed as quickly as possible, as the longer the stain remains the more difficult it will be to remove. Stains caused by so-called permanent markers and the like are designed to make removal difficult, the removal of such stains may not always be possible without causing damage to the coating surface. In such cases it may be necessary to recoat the affected area.

Areas of Use

Walls, hallways, ceilings, family rooms, bedrooms, laundry and bathroom.

Method of Application

  • Brush, roller or spray
  • Satisfactory with most equipment
  • Observe the State Spray Painting Regulations
  • Stir well before use using a broad, flat paddle in a scooping motion
  • Do not apply if temperature is below 10C or likely to fall below 10C during drying
  • Do not apply if rain is expected or in excessively hot, dry conditions

Coverage

  • Approximately 16 square metres per litre
  • Two coat coverage. (Coverage will vary depending on the profile and porosity of the painted surface)

Thinning

Water – Use up to 100ml per litre to aid application if necessary in hot, dry conditions.

Drying (25C and 50% Relative Humidity)

  • Dry to touch 25 Minutes
  • Recoatable after 2 Hours

Clean Up

Clean all equipment with water

Surface Preparation

Previously Painted Surface

Remove loose or flaking paint. Remove all traces of grease, dirt, oil or smoke stains using a suitable detergent. Wash with clean water and allow to dry. Repair any cracks or surface defects with a good quality filler. Sand surface until smooth and dust off with a cloth. Glossy surfaces should be sanded to remove gloss. Patchy surfaces require a coat of Australis PerfectPrep (undercoat).

Previously painted surfaces must be sound and have good adhesion. This can be checked by cutting an “X” in the surface with a sharp blade, press a piece of clear tape over the “X” as firmly as possible with the ball of the thumb then as quickly as possible, tear off the tape in one movement. If the previous paint comes off it must be removed before repainting.

Note: Mould, fungal infected surfaces and efflorescence must be treated to eliminate the possibility of recurrence.

Unpainted Paperfaced Wallboard, Fibro, Brick or Cement Surface

Dust down surfaces and apply one coat of Australis PerfectPrep.

Unpainted Fibrous Plaster

Dust down surface and apply one coat of Australis G.P. Oil Based Undercoat or Australis Binder Sealer.

Sizes

1 Ltr, 2 Ltrs, 4 Ltrs, 10 Ltrs, 15 Ltrs.
Sample Pots also available.

Bases

White/Light/Deep/Extra Bright Bases.

View the Material Safety Data Sheet (MSDS) for information regarding Health and Safety, First Aid, and Paint Disposal Procedures.

* AJAX SPRAY ‘N’ WIPE IS A REGISTERED TRADE MARK OF COLGATE – PALMOLIVE.