Australis Premium Ceiling Flat
Guaranteed for 12 Years.
Product Code: 815-100
Product Description
Australis Premium Ceiling Flat has been specially developed to give very high opacity, a dead flat appearance, and be tintable to standard colours equivalent to a white base. The formula will eliminate the need for a second coat on most surfaces and is easy to apply without messy spatter.
Special Features
- Very High Opacity
- One coat coverage
- Water Based
- Full strength tintable White
- Non yellowing
Areas of Use
Specifically designed for ceilings. May be used on walls in low traffic areas.
Method of Application
- Brush, roller or spray
- Satisfactory with most equipment
- Observe the State Spray Painting Regulations
- Stir well before use using a broad, flat paddle in a scooping motion
- Do not apply if temperature is below 10C or likely to fall below 10C during drying
- Do not apply if rain is expected or in hot dry conditions
Coverage
- Approximately 16 square metres per litre
- One coat coverage. (Coverage will vary depending on the profile, porosity and colour of the underlying painted surface)
Thinning
Water – Use up to 100ml per litre to aid application if necessary in hot, dry conditions.
Clean Up
Clean all equipment with water.
Surface Preparation
Previously Painted Surface
Remove loose or flaking paint. Remove all traces of grease, dirt, oil or smoke stains using a suitable detergent. Wash with clean water and allow to dry. Repair any cracks or surface defects with a good quality filler. Sand surface until smooth and dust off with a cloth. Glossy surfaces should be sanded to remove gloss. Patchy surfaces require a coat of Australis PerfectPrep (undercoat).
Previously painted surfaces must be sound and have good adhesion. This can be checked by cutting an “X” in the surface with a sharp blade, press a piece of clear tape over the “X” as firmly as possible with the ball of the thumb then as quickly as possible, tear off the tape in one movement. If the previous paint comes off it must be removed before repainting.
Note: Mould, fungal infected surfaces and efflorescence must be treated to eliminate the possibility of recurrence.
Unpainted Paperfaced Wallboard, Fibro, Brick or Cement Surface
Dust down surfaces and apply one coat of Australis PerfectPrep.
Unpainted Fibrous Plaster
Dust down surface and apply one coat of Australis G.P. Oil Based Undercoat or Australis Binder Sealer.
Sizes
1 Ltr, 2 Ltrs, 4 Ltrs, 10 Ltrs, 15 Ltrs .
Colours
White. Also tintable to standard colours equivalent to a white base.
View the Material Safety Data Sheet (MSDS) for information regarding Health and Safety, First Aid, and Paint Disposal Procedures.